AVerTV USB 2.0 Plus/Lite(M036) does not support Windows Vista or operating system later than Vista due to hardware limitation. Please be noted & understand.

2009-05-11

Please follow the steps below:
Download the patch file and save it into your hard drive.
Double click the patch file from the hard drive where you saved it.
Run the extracted file then updating the Software version.

2007-12-20

AVerTV USB 2.0 Plus/Lite(M036) does not support Windows Vista or operating system later than Vista due to hardware limitation. Please be noted & understand.

2009/5/11

Please check the attachment.

2007-12-21

Please check your USB port is 1.1 or 2.0 and make sure your USB power is good enough.   You can check your USB port under Universal Serial Bus controller of Device Manager. It's USB 2.0 if you can find our the wording of "Enhanced" in this item.

2007-12-28

Please follow below steps to solve your problem:

Step 1: Go to http://www.avermedia.com/avertv/Support/Download.aspx?Type=APDriver&tab=APDriver&id=39 to download and install the latest version.

Step 2: Please refer to the attachment for correctly remote control setup.

2008-04-11

A16A does not support MCE analog TV mode because it require MCE certified SW MPEG2 encoder and P4 3.2G or above CPU. Most of MCE analog TV cards do require an on board hardware MPEG-2 encoder (such as AVerMedia M150). However, A16A does not have on board hardware MPEG-2 encoder.

2007-11-20

2. Paste the folder in another place. Such as desktop or another partition.

3. Completely remove the previous driver and AVerTV program before installing the new version

4. After installation, copy the AVerTV folder that you saved before and overrride in the new AVerTV folder located in "My Document" or "Documents"

(Note that this is only applicable under the same computer with the same exact system configurations. In other word, under the same user account)

2008-03-20

2. Paste the folder in another place. Such as desktop or another partition.

3. Completely remove the previous driver and AVerTV program before installing the new version

4. After installation, copy the AVerTV folder that you saved before and overrride in the new AVerTV folder located in "My Document" or "Documents"

(Note that this is only applicable under the same computer with the same exact system configurations. In other word, under the same user account)

2008-03-20

1.      After you insert the device into the express slot, the system should automatically detect a newly installed hardware.

2.      Cancel the pop out windows, and insert the installation CD.

3.      The installation CD will autorun and choose install AVerTV.

4.      Run the installation step by step

5.      After installation is complete, you can go to device manager and check under “Sound, video and game control” for “Avermedia HC81R PCI-e Hybrid DVB-T” device or you can check if there is a small yellow icon located in the bottom right corner of the taskbar. Please refer to the attached file.

6.      If so, then the device has been successfully installed.  Therefore, you can proceed on doing the appropriate configuration for your device when executing the AVerTV.

2007-12-20